Ametek burst NX8 Quick Start Manual And Safety Instructions page 48

AMETEK CTS
1 Reference earth connection
2 Ventilator
3 Mains input
4 Power On Switch
5 DC output 0-10V (not used)
10 USB connector
USB connector "USB A" connector, same as the USB input at the front side.
11 USB interface (for service purpose)
USB interface "USB B" connector for service purpose with an external computer.
12 Ethernet interface
Ethernet interface for remote control from an external computer.
13 Opto Link interface
Optical interface for remote control from an external computer USB interface.
14 Sys Link output
Sys link is the internal control bus to the connected vsurge NX devices. The sys link is a daisy chain wired bus for connect
the devices in series. The bus includes a 26 pole high density connectors. This port is terminated with the SWL AD (Safety
Warning Lamp Adapter).
15 SYNC input (External)
External synchronization input for synchronize the generator impulse to this signal.
Input signal range: 10 V – 690 V.15Hz to 500 Hz
For each test with synchronization the generator measures the frequency. If no signal is detected, a window will propose to
continue in asynchronous mode.
6 Monitor V, Monitor I
7 Fail, EUT 1, EUT2
8 External Trigger IN
9 Sys Link IN
10 USB A interface
1.00
Quick start guide - Single pulse generators
11 USB B interface
12 Ethernet interface
13 Opto Link Interface
14 Sys Link OUT
15 Sync input
48 / 88