Ametek burst NX8 Quick Start Manual And Safety Instructions page 28

AMETEK CTS
1 AC EUT supply input
2 DC EUT supply input
3 Ventilator
4 Mains Switch
5 External Trigger IN
6 Fail, EUT 1, EUT2
5 External Trigger
One single event, burst, surge, voltage dip can be released. Trigger level 5V positive going.
BNC connector
Digital Input
Positive slope
Trigger Level:
Max- Input voltage: +10 V
Input protection 5 V: Transzorb diode
6 Fail input EUT 1, EUT 2
Programmable input monitors for fail events. Possible input settings: Notify, Stop, Break or Disabled
Input signal:
Max- Input voltage:
Input protection 15 V: Transzorb diode
7 USB interface A
USB interface "USB A" connector. Input plug for a memory stick for export / import test reports or test and link-files. The user
can load from this port setup pictures, updates and other files to the burst NX8 generator
8 USB interface B (for service purpose ONLY)
USB interface "USB B" connector for service purpose with an external computer. Using the USB interface may cause EMC
problems during burst tests at the computer or notebook side of the communication line. Therefore, only a high quality USB
cable shall be used.
9 Ethernet interface for REMOTE operation
Ethernet interface for remote control from an external computer.
7 USB A interface
8 USB B interface
9 Ethernet interface
10 Opto Link Interface
11 Sys Link OUT
12 Sys Link IN
50 Ω
(0 – 5 V)
2.5 V +/-1 V
5 V neg. slope
+20 V
Quick start guide - Single pulse generators
1.00
13 Sync input
14 Mains input device
15 Reference earth connection
28 / 88