Ametek burst NX8 Quick Start Manual And Safety Instructions page 66

AMETEK CTS
1 "Test On"
2 Function keys "F1...F7
3 Display
4 Exit
11 LED coupling
The LED Indicates the actual coupling mode for the 3-phase version.
12 EUT test supply
For single- or three-phase EUT the coupling/decoupling network is part of the generator. The EUT is powered via the safety
banana plugs at the front panel of the simulator
13 Direct HV and COM output
The HV and COM output are the designed for an external using of the impulse. This output is floating and is used for external
coupling/decoupling networks or magnetic field antenna.
The direct HV and COM output of the generator is located at the front panel of the instrument. It is not
allowed to connect these outputs to any other coupling/decoupling network than manufactured by AMETEK
CTS, e.g. the types CNV or CNI.
Before to connect any external networks to this output the operator must contact the manufacturer. Any
damages due to this matter are not covered by warranty.
The direct pulse output shall also not be used to connect the generator directly to any power conducting
Attention lines.
5 Cursor keys "" and "→"
6 Knob (Inc. / Dec)
7 Escape
CRO trigger output  5V
8
1.00
Quick start guide - Single pulse generators
9 LED coupling 1 ph. version
10 EUT test supply L, N, PE 1ph version
11 LED coupling 3 ph. version
12 EUT test supply 3-phase version
Direct output HV – COM
13
66 / 88