Rear View Vsurge Nx20 - Ametek burst NX8 Quick Start Manual And Safety Instructions

AMETEK CTS
7.14.

Rear view vsurge NX20

1 Reference earth connection
2 Ventilator
3 Mains input
4 Power On Switch
5 DC output 0-10V (not used)
1 Reference earth connection
The generator must be connected to the reference earth plane of the test set up. The connection at the rear part of the
generator is an alternative to the grounding point at the front panel
2 Ventilation
A power controlled ventilator is cooling the vsurge NX20 generator. During the most application, the ventilator runs with
variable speed depends the cooling requirement.
After long term duration tests the generator should keep on running for some minutes to cool down the system.
3 Mains Input and Fuse
Mains input for the generator power supply.
85 V – 254 V ac
Input voltage:
Fuses: 115 V:
230 V:
4 Power on switch
The switch is part of the mains filter. Mains fuses are part of the filter. (230V / 2A and 115V / 4A)
5 DC output 0-10 V
DC output for control not supported in this device
6 Monitor V and Monitor I (BNC connector)
This function is not supported for this generator
6 Monitor V, Monitor I, (not used)
7 Fail, EUT 1, EUT2
8 External Trigger IN
9 Sys Link IN
10 USB A interface
4 A slow blow, 5 x 20 mm.
2 A slow blow, 5 x 20 mm
Quick start guide - Single pulse generators
1.00
11 USB B interface
12 Ethernet interface
13 Opto Link Interface
14 Sys Link OUT
15 Sync input
46 / 88