Table of Contents
Advertisement
AMETEK CTS
1
AC EUT supply input
2
DC EUT supply input
3
Ventilator
4
Mains Switch
5
External Trigger IN
6
Fail, EUT 1, EUT2
10
Opto Link interface for REMOTE operation
USB to Opto Link interface for remote control from an external computer (Baud rate 9.600 Bd).
11
Sys Link output
Sys link is the internal control bus to the connected burst NX8 devices. The sys link is a daisy chain wired bus for connect the
devices in series. The bus includes a 26 pole high density connector. This port is terminated with the SWL AD (Safety
Warning Lamp Adapter).
12
Sys Link input
Sys link is the internal control bus to the connected burst NX8 devices. The sys link is a daisy chain wired bus for connect the
devices in series. The bus includes a 26 pole high density connector. This port is terminated with the SSC AD Safety circuit
adapter with a short circuit.
The max power for the warning lamp signal lines is 60 V AC/DC, 2 A.
13
SYNC input (external)
External synchronization input for synchronize the generator impulse to this signal. For each test with synchronization the
generator measures the frequency. If no signal is detected, a window will propose to continue in asynchronous mode.
Input signal range: 10 V – 690 V.15 Hz to 500 Hz
Internal synchronization detects the signal from input L1.
14
Mains input and fuse
Mains input for the generator power supply.
85 V – 254 V ac
Input voltage:
Fuses:
115 V:
230 V:
Rated power:
15
Reference earth connection
The generator must be connected to the reference earth plane of the test set up. The connection at the rear
side of the generator is an alternative to the grounding point at the front panel.
7
USB A interface
8
USB B interface
9
Ethernet interface
10 Opto Link Interface
11 Sys Link OUT
12 Sys Link IN
4 A slow blow, 5 x 20 mm.
2 A slow blow, 5 x 20 mm
75 W
Quick start guide - Single pulse generators
1.00
13 Sync input
14 Mains input device
15 Reference earth connection
29 / 88
Advertisement
Table of Contents
