Table of Contents
Advertisement
AMETEK CTS
10.5.
Front view OCS 500N6F.x
1
"Test On"
2
Function keys "F1..F7
3
Display
4
Exit
1
Test On
By pressing the key "Test On" the power supply of the high voltage part will be ready for start. The red LED indicates the
trigger of a burst event.
2
Function keys "F1 ... F7
Parameters and functions, displayed in the lowest line, can be selected with the related function key.
3
Display
All functions and parameters are displayed (8 lines with max. 40 characters).
4
Exit
Pressing of the Exit function will cause a reset of the firmware. This is only possible if no test routine is running.
5
Cursor keys
Parameters and functions can be changed on-line. The selection of these parameters is realized with the cursor moving to
the left or to the right.
6
Knob (Inc. / Dec)
The knob increments or decrements test parameters with a numeric value or selects from a list of parameters.
7
ESC
When pressing the ESC button the user moves back one page in the menu. The displayed parameters before are stored.
8
Trigger
At the BNC output (5V pos slope) the generator trigger can be used as oscilloscope trigger output. It is synchronous to the
impulse events.
5
Cursor keys "" and "→"
6
Knob (Inc. / Dec)
7
Escape
Trigger output 5V
8
1.00
Quick start guide - Single pulse generators
9
LED mains coupling 1/3 ph.
10
EUT test supply 1ph/3ph
11
Fast damped output for I/O lines
Direct output HV – COM
12
69 / 88
Advertisement
Table of Contents
