Table of Contents
Advertisement
AMETEK CTS
1
Active indication
2
Touch screen
3
Knob (Inc. / Dec /Enter)
4
" Test On"
CRO Trigger output 5V
5
HV pulse burst output 50
6
External coupling devices such as the capacitive coupling clamp and the 3-phase coupling networks are connected to the
coaxial 50 ohm output. Also, the calibration of the generator is handled at this output. Note: The burst signal is present on this
output at every coupling mode.
The 50 output must not be used without a load. The dielectric strength is only sufficient when
plugged in.
Attention
7
EUT test supply
For single-phase or 3-phase EUT the coupling/decoupling network is part of the generator, depending on the model. The
EUT is powered via the safety banana plugs at the front panel of the simulator.
For verification or impulse measuring, you must take care, to use measuring instruments, which are
able to handle the high voltage transients up to 8.0 kV.
Attention
8
Ground reference
The ground reference (4mm) is used for EFT/Burst calibration adapters
9
START / PAUSE button
- Green indication: Start or continues a test
- Orange indication: Pause of a running test
HV pulse Burst output 50
6
7
EUT test supply
8
Ground reference (calibration)
9
Start / Pause
10
Stop
1.00
Quick start guide - Single pulse generators
11
Back
12
AC / DC test supply
Coupling mode (50 output)
13
14
Coupling mode (supply lines)
15
USB input (Memory stick)
25 / 88
Advertisement
Table of Contents
