Ametek burst NX8 Quick Start Manual And Safety Instructions page 47

AMETEK CTS
1 Reference earth connection
2 Ventilator
3 Mains input
4 Power On Switch
5 DC output 0-10V (not used)
7 Fail input EUT 1, EUT 2
Programmable input monitors for fail events. Possible input settings: Notify, Stop, Break or Disabled
Input signal:
Max- Input voltage:
8 External trigger
One single event, burst, surge, voltage dip can be released. Trigger level 5V positive going.
BNC connector
Digital Input
Positive slope
Trigger Level:
Max- Input voltage: +24 V
9 Sys Link input
Sys link is the internal control bus to the connected vsurge NX devices. The sys link is a daisy chain wired bus for connect
the devices in series. The bus includes a 26 pole high density connectors. This port is terminated with the SSC AD Safety
circuit adapter with a short circuit.
6 Monitor V, Monitor I
7 Fail, EUT 1, EUT2
8 External Trigger IN
9 Sys Link IN
10 USB A interface
5 V pos. slope
+24 V
50 Ω
(0 – 5 V)
2.5 V +/-1 V
Quick start guide - Single pulse generators
1.00
11 USB B interface
12 Ethernet interface
13 Opto Link Interface
14 Sys Link OUT
15 Sync input
47 / 88