Awd / 2Wd / Turf Switch (Int'l); Turn Signal Switch (Int'l); Hazard Switch (Int'l) - Polaris 2011 RANGER RZR Service Manual

ELECTRICAL

AWD / 2WD / TURF Switch (INT'L)

1. Disconnect the AWD / 2WD / TURF switch harness by
depressing the connector locks and pulling on the
connector. Do not pull on the wiring.
2. Test between the 3 sets of outputs (AWD / 2WD / TURF).
If any of the tests fail, replace the switch assembly.
• Move the switch to AWD. There should be continuity
between switch pins 2 and 3; 5 and 6.
• Move the switch to 2WD. There should be no
continuity between any pins.
• Move the switch to TURF. There should be continuity
between switch pins 1 and 2; 4 and 5.
10.6
9923142 - 2011 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2010 Polaris Sales Inc.

Turn Signal Switch (INT'L)

1. Disconnect the Turn Signal switch harness by depressing
the connector locks and pulling on the connector. Do not
pull on the wiring.
2. Test between the 5 sets of outputs (HI BEAM / LO BEAM
/ L-TURN / R-TURN / HORN). If any of the tests fail,
replace the switch assembly.
Orientation
Tab
1 2
HI BEAM
LO BEAM
L - TURN
R - TURN
HORN

Hazard Switch (INT'L)

1. Disconnect the wires from the Hazard switch.
2. Test between the 2 sets of outputs (ON / OFF). If any of the
tests fail, replace the switch assembly.
• Move the switch to ON. There should be continuity
between the switch legs 1 and 2.
• Move the switch to NONE / OFF. There should be no
continuity between the switch legs.
3 4 6 7 8 9