Table of Contents
Advertisement
®
R&S
TSMA6B
8. Click "Install".
Note: Do not switch off or unplug from power while running firmware/software
update.
9. The state of the installation process is displayed in the "Status" column. The proc-
ess is finished when the status indicates "Ready...".
10. Press "Exit".
11. Reload the R&S TSMA6B web GUI (see
web
"Overview".
12. To configure the required measurement mode, see
surement
The R&S TSMA6B is ready for operation.
8.2.5 Local installation using a USB stick
The setup will be initiated via the web GUI of the R&S TSMA6B. In this case, the setup
file must be available in the root directory of a USB stick, which is connected to the
R&S TSMA6B.
1. Connect mouse, keyboard to the USB ports and a monitor.
2. Switch on the R&S TSMA6B via power button.
User Manual 4901.4026.02 ─ 01
GUI",
on page 60) and verify the installed firmware /software version in the
mode",
on page 39.
Updating firmware/software/tools - general instructions
Chapter 8.2.1, "Calling R&S TSMA6B
Update and restore
Chapter 6.3, "Selecting mea-
68
Advertisement
Table of Contents
