Table of Contents
Advertisement
®
R&S
TSMA6B
6.3 Selecting measurement mode
Select the measurement mode with the following steps.
1. Check the prerequisites of the desired measurement mode (see
"Measurement
requirements.
2. Start the R&S TSMA6B web GUI (see
web
3. Select the measurement mode in the R&S TSMA6B web GUI, the modes are
described in
6.3.1 Measurement modes
The measurement modes can be configured via the radio button from the web GUI
under "Configuration" > "System" > "Mode".
The "rViCom" and" PC Mode" are selectable on all the R&S TSMA6Bs. The other
modes (NESTOR, ROMES, QualiPoc) are only selectable if the appropriate SW appli-
cations are installed (see
User Manual 4901.4026.02 ─ 01
modes",
on page 39) and adjust your device according to these
GUI",
on page 35).
Chapter 6.3.1, "Measurement
Chapter 8.4, "Software update -
Configuring the R&S TSMA6B
Selecting measurement mode
Chapter 6.2.1, "Using the R&S TSMA6B
modes",
on page 39.
details",
Chapter 6.3.1,
on page 72).
39
Advertisement
Table of Contents
