Installation Using A Usb Stick - R&S TSMA6 User Manual

®
R&S TSMA6
16. To configure the required measurement mode, see
surement
The R&S TSMA6 is ready for operation.

8.3.3 Installation using a USB stick

The setup will be initiated via the web GUI of the R&S TSMA6. In this case, the setup
file must be available in the root directory of a USB stick, which is connected to the
R&S TSMA6. To initiate the setup, a tablet or handheld device is used usually, which is
connected via LAN or WLAN with the R&S TSMA6.
1. Connect a mouse and a keyboard to the USB ports and a monitor to the HDMI
port.
2. Switch on the R&S TSMA6 via the power button.
3. Copy the setup file onto a USB memory stick.
a) For firmware installation: Copy the firmware setup file
b) For software installation: Copy the corresponding setup file into the root direc-
4. Open the R&S TSMAx web GUI (see
GUI",
5. Make sure that the "Mode of Operation" is "PC Mode". Otherwise switch the device
to "PC Mode", see
6. In the R&S TSMAx web GUI, navigate to the menu "Update".
7. Select the appropriate setup file from one of the combo boxes.
●
●
8. Select "Update Firmware/Software" next to the select box.
The "Update" buttons are only active, if a valid setup file is available on the USB
stick and the device is in "PC Mode".
User Manual 4900.8057.02 ─ 11
mode", on page 47.
TSMAx-Setup-<Version>.zip into the root directory of the stick.
tory of the stick.
on page 95).
Chapter 8.2,
Firmware: "Select Firmware Setup File"
Software/Tools: Select the corresponding software box.
Installing firmware and software updates
Updating firmware/software/tools - general instructions
Chapter 8.3.4, "Calling R&S TSMA6 web
"Prerequisites", on page 82.
Chapter 6.4, "Selecting mea-
92