Table of Contents
Advertisement
®
R&S
TSMA6B
6 Configuring the R&S TSMA6B
6.1 Changing IP adresses
To change the IP addresses, refer to the following.
●
Chapter A.2.2.4,
●
Chapter A.2.2.5, "LAN
6.2 Accessing the R&S TSMA6B
There are different ways to control measurements on the R&S TSMA6B.
●
Local operation
To use the R&S TSMA6B as an ordinary PC, an external monitor, mouse and key-
board have to be connected to the R&S TSMA6B.
●
Remote access
The remote access to the R&S TSMA6B can be realized via the following options.
–
–
6.2.1 Using the R&S TSMA6B web GUI
The R&S TSMA6B web GUI gives the user full access to control and measure with the
R&S TSMA6B. Following tasks can be done:
●
Recall of system information / hardware software versions / IP settings
●
Configure measurement mode / power up/down behavoir / band selection
●
Configure LAN / WLAN & Bluetooth settings / IP configuration
●
File transfer (upload / download)
●
Show and install SW licenses
●
Update firmware and software
●
Create a user backup
●
Restart device / scanner part
●
Access online help
To access the R&S TSMA6B web GUI, use one of the following possibilities.
User Manual 4901.4026.02 ─ 01
"LAN",
on page 131
EXT1",
Using the web GUI of the R&S TSMA6B (see
TSMA6B web
GUI",
on page 35).
Establish a remote desktop connection (via LAN/WLAN) (see
"Using a remote desktop
Configuring the R&S TSMA6B
on page 132
Chapter 6.2.1, "Using the R&S
connection",
on page 37).
Accessing the R&S TSMA6B
Chapter 6.2.2,
35
Advertisement
Table of Contents
