Connecting Power Supply; Connecting To A Vehicle Dc Power Supply - R&S TSMA6B User Manual

®
R&S TSMA6B
To select the correct connectors, refer to
1. Connect the RF antenna to the RF IN connector (see
2. Connect the GPS antenna to the GPS ANT port (see
3. Connect mouse and keyboard to the USB ports (see
to the appropriate monitor port (HDMI, USB-C)) (see
want to use local operation. (optional)
4. Connect a LAN cable to the LAN port if you want to use the R&S TSMA6B via
Remote Desktop or as distributed system (optional). (See
5. OPTIONAL: Connect external devices/storage devices and test mobile phones to
USB 2.0 / USB 3.0 / USB-C ports (see

5.3 Connecting power supply

This section describes how to connect the R&S TSMA6B to a power supply unit.

5.3.1 Connecting to a vehicle DC power supply

For 12V vehicle DC supply only
The R&S TSMA6B is to be used with a 12 V vehicle DC power supply network only.
Use the accessory DC cable with cigarette lighter adapter to power the R&S TSMA6B
from the vehicle power supply. Connect the 7-pin connector to DC IN.
Connecting a proprietary power supply
► To use a proprietary DC supply with the R&S TSMA6B power cable, demount the
cigarette lighter adapter from the supplied power cable and connect the open ends
of the cable to the proprietary power supply. Ensure that the polarity is correct. (see
Figure
User Manual 4901.4026.02 ─ 01
5-1).
Connecting power supply
Chapter 3, "Instrument
Figure 3-2
Figure 3-2
Figure 3-2
Figure 3-2
Figure 3-2
Figure 3-2 - 9, 10, 11).
Preparing for use
tour", on page 12.
- 17).
- 16).
- 11) and a monitor
- 11, 12) if you
- 12.)
23