No Remote Access Via Lan Port - R&S TSMA6B User Manual

®
R&S TSMA6B

9.8 No remote access via LAN port

If the R&S TSMA6B could not be accessed for remote control or remote desktop ses-
sion via the LAN port, check following issues:
Optical Check
1. Check on the rear panel, if the LAN cable is connected to the remote control LAN
port (see connector (14) in
The LAN port is marked with the LAN symbol.
The default setting for this port is "DHCP client". The R&S TSMA6B obtains the IP
address automatically.
2. If the LAN cable was not connected to the correct LAN port, correct the cabling and
try the remote access again. Otherwise, continue with
web
3. Check the LEDs at the LAN port.
●
●
Verify LAN Settings in the Web GUI
1. Open the web GUI (see
The predefined start page is http://localhost.
Note: If the web GUI cannot be started local, contact the R&S support.
2. Check if an IP address is displayed in the web GUI. Does this IP address match
with the IP settings of the remote PC (IP subnet range)?
See
If no LAN Port address is displayed, continue with
Connections.
User Manual 4901.4026.02 ─ 01
GUI.
LED on the left (Link)
orange permanent
LED on the right (Activity)
yellow blinking
Local access from the TSMA6B and Windows
Figure 9-6.
Figure 3-2.
Troubleshooting
No remote access via LAN port
Verify LAN Settings in the
Explorer).
Check R&S TSMA6 Network
108