Table of Contents
Advertisement
®
R&S
TSMA6B
2. Configure the following settings. For the initial settings after installation, see
ter 8.4.3.3, "Initial software start / measurement mode
●
●
●
●
3. Click "Submit" to save your selection.
For more details about the R&S SmartONE configuration and usage, refer to the user
documentation for R&S SmartONE.
6.3.1.6
Scanner mode
You can use the R&S TSMA6B as scanner only. In this case, the R&S TSMA6B
behaves like a R&S TSME6. The internal CPU is not powered, only the scanner is
switched on.
Scanner mode
To use the R&S TSMA6B in scanner mode, proceed as follows.
1. Use a pointed object to push the CPU switch (1) to position 0.
User Manual 4901.4026.02 ─ 01
Autostart
Workspace File
In the drop-down menu, select a ROMES workspace file (see
ROMES workspace file"
Recording
Activating this checkbox, the SmartONE measurement data are written to the
TSMA6B hard disk.
IP Controlled
Activating this checkbox, you can control the SmartONE measurement via IP
from an external host PC.
Configuring the R&S TSMA6B
on page 48).
Selecting measurement mode
selection",
on page 80.
"Import of
Chap-
46
Advertisement
Table of Contents
