Evaluate Selftest File; Verify Scanner Link / Recall Device Info Using Tsmedevicemanager - R&S TSMA6B User Manual

®
R&S TSMA6B

9.2 Evaluate selftest file

●
Path: C:\ProgramData\Rohde-Schwarz\TSMA\Selftestresults
●
Filename: Selftestresult.txt
Entries in the Selftestresult.txt are created during the boot process of the
device and every 5 minutes.
To open the Selftestresult.txt, proceed as follows.
1. Open a file explorer.
2. Enter the path to the directory where the selftest file is stored.
3. Open the selftest file.
Following device parameters and values are stored.
●
Internal voltages (nominal values / actual values)
●
Temperatures (scanner / mainboard)
●
Battery status info
●
Status of fans
●
Status of scanner interface
9.3 Verify scanner link / recall device info using TsmeDe-
viceManager
1. To start the R&S TSME Device Manager, double-click the desktop icon or select in
Windows:
"Start" > "All Programs" > "TsmeTools" > "TsmeDeviceManager"
2. Following error messages may occur.
●
●
3. If the" Device Info" tab (see
nection has been established successfully.
4. Check the "Device Analysis Output" (see
on page 99) and the "Options" (see
on page 100) .
User Manual 4901.4026.02 ─ 01

Verify scanner link / recall device info using TsmeDeviceManager

Tsme Device Manager Application has stopped
In the web GUI, check "Mode of Operation". If necessary, change to "PC Mode"
and try again.
No TSME connected
In the web GUI, verify "Scanner LAN Port Settings".
Figure 9-1) contains scanner data, the scanner con-
Chapter 9.3.2, "Device analysis
Chapter 9.3.3, "Verify installed license
Troubleshooting
output",
keys",
97