Table of Contents
Advertisement
®
R&S
TSMA6B
B.3.4.2
LTE Top Signal Scan Results
The LTE scan result graph displays one column for each PCI found by the measure-
ment. The height of a column represents the PBCH RSRP value (in dBm).
Figure B-10: LTE Scan Result View
Below the graph the measurement preferences and the status are displayed.
Parameters
Displays the configured preferences for the LTE scan.
Status
Displays the measurement duration and the measurement rate. The status button dis-
plays the following colored states.
●
Green
The measurement is running and measurement data are received.
●
Yellow
The measurement is running but no measurement data are received.
●
Red
The measurement was stopped.
► To stop the scan, use "Stop scan" in the menu inflator in the top right corner.
B.3.5 Throughput Test Case
The throughput test case is useful to find out the throughput speed of your connection.
This allows to decide, which connection type (WLAN or Bluetooth) should be used.
B.3.5.1
Throughput Preferences
To start the throughput test, the following steps must be performed.
User Manual 4901.4026.02 ─ 01
Introduction to Remote ViCom Sample App
Usage
145
Advertisement
Table of Contents
