Table of Contents
Advertisement
®
R&S
TSMA6B
NESTOR probe mode
1. On the "Mode" tab, select "NESTOR Probe" mode.
2. Press "Submit".
The R&S TSMA6B is switched into "NESTOR Probe" mode. In the status bar, the
entry is "Changing mode of operation in progress...".
The mode switch is finished when the status bar indicates "No error". The scanner
state LED starts blinking rapidly.
The NESTOR measurement is started and controlled from the host PC.
For more details about the R&S NESTOR configuration and usage, refer to the user
documentation for R&S NESTOR.
6.3.1.5
SmartONE mode
The SmartONE mode is only displayed if the SmartONE setup has been executed (see
Chapter 8.4.3, "R&S SmartONE setup (SmartBenchmarker, ROMES,
on page 79).
To use the R&S TSMA6B with R&S SmartONE, the following steps must be performed.
1. In the web GUI, set the "Mode of Operation" to one of the following SmartONE
modes and press "Submit".
●
●
User Manual 4901.4026.02 ─ 01
"SmartONE Standard"
Activating this mode, a web based UI with the SmartBenchmarker application
software, designed for efficient data collection and remote control support in
combination with SmartMonitor can be used.
"SmartONE Expert"
Activating this mode, an expert UI with the ROMES4 application software for
complex measurement tasks and detailed data investigation during the mea-
surement can be used.
Configuring the R&S TSMA6B
Selecting measurement mode
QualiPoc)",
45
Advertisement
Table of Contents
