Installation Using A Usb Stick - R&S TSMA6 Series User Manual
Autonomous mobile network scanner
Hide thumbs
Also See for TSMA6 Series:
- User manual (190 pages) ,
- Getting started (51 pages) ,
- Manual (10 pages)
Table of Contents
Advertisement
®
R&S
TSMA6
8. Click "Install".
Note: Do not switch off or unplug from power while running firmware/software
update.
9. The state of the installation process is displayed in the "Status" column. The proc-
ess is finished when the status indicates "Ready...".
10. Press "Exit".
11. Reload the R&S TSMA6 web GUI (see
GUI",
"Overview".
The R&S TSMA6 is ready for operation.
7.1.2.3
Installation Using a USB Stick
The setup will be initiated via the web GUI of the R&S TSMA6. In this case, the setup
file must be available in the root directory of a USB stick, which is connected to the
R&S TSMA6.
If a restart is performed during the setup, the message System is Restarting is dis-
played in the status bar. For a short time, the web GUI is not accessible.
Do not interrupt the browser session on the remote PC. After a successful update, the
web GUI will be refreshed.
1. Connect mouse, keyboard to the USB ports and a monitor.
User Manual 4900.8057.02 ─ 06
on page 62) and verify the installed firmware /software version in the
Update and Restore
Chapter 7.1.3, "Calling R&S TSMA6 Web
Firmware Update
58
Advertisement
Table of Contents
