Smartone Mode - R&S TSMA6 User Manual

®
R&S TSMA6
For more details about the R&S NESTOR configuration and usage, refer to the user
documentation for R&S NESTOR.
6.4.1.5

SmartONE mode

The SmartONE modes are only displayed if SmartONE software is installed (see
Chapter 8.6.3, "R&S SmartONE setup (SmartBenchmarker, ROMES,
on page 109).
To use the R&S TSMA6 with R&S SmartONE, the following steps must be performed.
1. In the web GUI, set the "Mode of Operation" to one of the following SmartONE
modes and press "Submit".
●
●
●
User Manual 4900.8057.02 ─ 11
"SmartONE Standard" (1)
Activating this mode, a web-based UI with the SmartBenchmarker application
software, designed for efficient data collection and remote control support in
combination with SmartMonitor can be used.
"SmartONE Expert" (1)
Activating this mode, an expert UI with the ROMES4 application software for
complex measurement tasks and detailed data investigation during the mea-
surement can be used.
For the initial settings after installation, see
start / measurement mode
"Smart Monitor" (2)
Activating this mode, a central, web-based module for controlling and monitor-
ing a fleet of QualiPoc android probes can be used.
Configuring the R&S TSMA6
Selecting measurement mode
Chapter 8.6.3.4, "Initial software
selection", on page 111.
QualiPoc)",
54