Measurement Setup; Measurement Modes; Remote Vicom Server Mode - R&S TSMA6 User Manual

®
R&S TSMA6

6.2 Measurement Setup

The measurement setup procedure is performed in the following steps.
1. Start the R&S TSMA6 Web-GUI (see
GUI",
2. Check the prerequisites of the desired measurement mode (see
"Measurement
requirements.
3. Select the measurement mode in the R&S TSMA6 Web-GUI, the modes are
described in

6.3 Measurement Modes

To setup a measurement, see
The measurement modes can be configured via the Web-GUI under "Configuration" >
"System" > "Mode".
The R&S Remote ViCom Server is installed on all the R&S TSMA6s.
The other software applications, that is, the R&S NESTOR, R&S ROMES and Quali-
Poc are installed only if ordered.

6.3.1 Remote ViCom Server Mode

The connection between the Remote ViCom server on the R&S TSMA6 and the client
application (Remote ViCom client) on the handheld device can be realized via Blue-
tooth
The selection of the wireless interface type depends on the measurement task.
The WLAN connection allows a throughput, which is about 10 times higher compared
to Bluetooth.
The Bluetooth
Preparations for using the Bluetooth
The device must be in the PC Mode. Check it via the Web-GUI ("Home" > "Overview").
To change the operation mode, navigate to "Configuration" > "System" > "Mode" and
select an operation mode.
1. Switch on Bluetooth
User Manual 4900.8057.02 ─ 01
on page 24).
Modes",
Chapter 6.3, "Measurement
®
or WLAN.
®
connection is less influenced by interference.
®
and WLAN on R&S TSMA6.
Chapter 6.1.1, "Start the R&S TSMA6 Web-
on page 27) and adjust your device according to these
Modes",
Chapter 6.2, "Measurement
®
interface
Configuring the R&S TSMA6
Measurement Modes
Chapter 6.3,
on page 27.
Setup", on page 27.
27