D-Link xStack DES-3800 Series Cli Manual page 125

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
DES-3800:4#
show link_aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display Link Aggregation configuration:
DES-3800:4#show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = MAC-source-dest
Group ID
Master Port
Member Port
Active Port
Status
Flooding Port
DES-3800:4#
config lacp_ports
Purpose
Syntax
Description
Parameters
Used to display the current link aggregation configuration on the
Switch.
show link_aggregation {group_id <value 1-32> | algorithm}
This command will display the current link aggregation configuration
of the Switch.
<value 1-32> − Specifies the group ID. The Switch allows up to 32
link aggregation groups to be configured. The group number
identifies each of the groups.
algorithm − Allows you to specify the display of link aggregation by
the algorithm in use by that group.
None.
: 1
: 1
: 5-10
:
: Disabled
: 5
Used to configure settings for LACP compliant ports.
config lacp_ports <portlist> mode [active | passive]
This command is used to configure ports that have been previously
designated as LACP ports (see create link_aggregation).
<portlist> − Specifies a port or range of ports to be configured.
mode – Select the mode to determine if LACP ports will process
LACP control frames.
•
active – Active LACP ports are capable of processing and
sending LACP control frames. This allows LACP compliant
devices to negotiate the aggregated link so the group may
be changed dynamically as needs require. In order to utilize
the ability to change an aggregated port group, that is, to
120