D-Link xStack DES-3800 Series Cli Manual page 61

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
#
#
#
#
#-------------------------------------------------------------------
# BASIC
config serial_port baud_rate 9600 auto_logout 10_minutes
enable telnet 23
enable web 80
# STORM
config traffic control 1-5 broadcast disable multicast disable dlf
disable thres
hold 128
# GM
config sim candidate
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
upload
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To upload a configuration file:
DES-3828 Configuration
Firmware: Build 3.01-B121
Copyright(C) 2000-2004 D-Link Corporation. All rights reserved.
Used to upload the current switch settings or the switch history log
to a TFTP.
upload [ configuration | log ] <ipaddr> <path_filename 64>
This command is used to upload either the Switch's current settings
or the Switch's history log to a TFTP server.
configuration − Specifies that the Switch's current settings will be
uploaded to the TFTP server.
log − Specifies that the switch history log will be uploaded to the
TFTP server.
<ipaddr> − The IP address of the TFTP server. The TFTP server
must be on the same IP subnet as the Switch.
<path_filename 64> − Specifies the location of the Switch
configuration file on the TFTP server. This file will be replaced by
the uploaded file from the Switch.
The TFTP server must be on the same IP subnet as the Switch.
Only administrator-level users can issue this command.
56