Igmp Commands - D-Link xStack DES-3800 Series Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual

IGMP Commands

The IGMP commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
config igmp
show igmp
show igmp group
Each command is listed, in detail, in the following sections.
config igmp
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
Parameters
[ipif <ipif_name 12>|all] { version <value 1-2>| query_interval
<sec 1-65535>| max_response_time <sec 1-25> |
robustness_variable <value 1-255> |last_member_query_interval
<value 1-25>| state [enable|disable]}
{ipif <ipif_name 12>}
{group <group> | ipif <ipif_name 12>}
Used to configure IGMP on the Switch.
[ipif <ipif_name 12>|all] { version <value 1-2>| query_interval
<sec 1-65535>| max_response_time <sec 1-25> |
robustness_variable <value 1-255>|last_member_query
_interval <value 1-25>| state [enable|disable]}
This command allows you to configure IGMP on the Switch.
<ipif_name 12> − The name of the IP interface for which you
want to configure IGMP.
all − Specifies all the IP interfaces on the Switch.
version <value 1-2> − Select the IGMP version number.
query_interval <sec 1-65535> − The time in seconds between
general query transmissions, in seconds.
max_response_time <sec 1-25> − Enter the maximum time in
seconds that the Switch will wait for reports from members.
robustness_variable <value 1-255> − This value states the
permitted packet loss that guarantees IGMP.
last_member_query_interval <value 1-25> − The Max Response
Time inserted into Group-Specific Queries and Group-and-
Source specific queries sent in response to Leave Group
messages, and is also the amount of time between Group-
Specific Query and Group-and-Source specific query messages.
The default is 1 second
state [enable | disable] − Enables or disables IGMP for the
specified IP interface.
Only administrator-level users can issue this command.
130
19