D-Link xStack DES-3800 Series Cli Manual page 133

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
show ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display IP interface settings.
DES-3800:4#show ipif System
Command: show ipif System
IP Interface Settings
Interface Name : System
IP Address
Subnet Mask
VLAN Name
Admin. State
Link Status
Member Ports
Total Entries : 1
DES-3800:4#
enable autoconfig
Purpose
Syntax
Description
Parameters
DES-3800:4#config ipif System ipaddress 10.48.74.122/8
Command: config ipif System ipaddress 10.48.74.122/8
Success.
DES-3800:4#
Used to display the configuration of an IP interface on the Switch.
show ipif {<ipif_name 12>}
This command will display the configuration of an IP interface on
the Switch.
<ipif_name 12> − The name created for the IP interface.
None.
: 10.48.74.122
: 255.0.0.0
: default
: Disabled
: Link UP
: 1-26
Used to activate the autoconfiguration function for the Switch. This will load a
previously saved configuration file for current use.
enable autoconfig
When autoconfig is enabled on the Switch, the DHCP reply will contain a
configuration file and path name. It will then request the file from the TFTP server
specified in the reply. When autoconfig is enabled, the ipif settings will
automatically become DHCP client.
None.
(MANUAL)
128