D-Link xStack DES-3800 Series Cli Manual page 173

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
Example usage:
To configure a rule for the Ethernet access profile:
DES-3800:4#create access_profile ip protocol_id profile_id 2
Command: create access_profile ip protocol_id profile_id 2
Success.
DES-3800:4#
config access_profile profile_id (IP)
Purpose
Syntax
Description
Parameters
Used to configure the IP access profile on the Switch and to define
specific values for the rules that will be used to by the Switch to
determine if a given packet should be forwarded or filtered. Masks
entered using the create access_profile command will be
combined, using a logical AND operational method, with the values
the Switch finds in the specified frame header fields.
config access_profile profile_id <value 1-8> [add access_id
<value 1-100> ip {vlan <vlan_name 32> | source_ip <ipaddr> |
destination_ip <ipaddr> | dscp <value 0-63> | [icmp {type <value
0-255> code <value 0-255>} | igmp {type <value 0-255>} | tcp
{src_port <value 0-65535> | dst_port <value 0-65535> | urg | ack
| psh | rst | syn | fin} | udp {src_port <value 0-65535> | dst_port
<value 0-65535>} | protocol_id <value 0 - 255> {user_define
<hex 0x0-0xffffffff>}]} port <port> [permit {priority <value 0-7>
{replace_priority} | replace_dscp <value 0-63>} | deny] delete
<value 1-100>]
This command is used to define the rules used by the Switch to
either filter or forward packets based on the IP part of each packet
header.
profile_id <value 1-8> - Enter an integer between 1 and 8 that is
used to identify the access profile that will be configured with this
command. This value is assigned to the access profile when it is
created with the create access_profile command. The lower the
profile ID, the higher the priority the rule will be given.
add access_id <value 1-100> - Adds an additional rule to the above
specified access profile. The value specifies the relative priority of
the additional rule. Up to 100 different rules may be configured for
the IP access profile.
ip − Specifies that the Switch will look into the IP fields in each
packet to see if it will be either forwarded or filtered based on one or
more of the following:
vlan <vlan_name 32> − Specifies that the access profile will
•
apply to only to this VLAN.
source_ip <ipaddr> − Specifies that the access profile will
•
apply to only packets with this source IP address.
destination_ip <ipaddr> − Specifies that the access profile will
•
apply to only packets with this destination IP address.
dscp <value 0-63> − Specifies that the access profile will apply
•
only to packets that have this value in their Type-of-Service
(DiffServ code point, DSCP) field in their IP packet header.
icmp − Specifies that the Switch will examine the Internet
•
168