D-Link xStack DES-3800 Series Cli Manual page 60

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
'*' means boot up section
(T) means firmware update thru TELNET
(S) means firmware update thru SNMP
(W) means firmware update thru WEB
Free space: 3145728 bytes
DES-3800:4#
show config
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To view the current configuration settings:
DES-3800:4#show config current_config
Command: show config current_config
#-------------------------------------------------------------------
Used to display the current or saved version of the configuration settings of the
switch.
show config [ current_config | config_in_nvram ]
Use this command to display all the configuration settings that are saved to NV
RAM or display the configuration settings as they are currently configured. Use the
keyboard to list settings one line at a time (Enter), one page at a time (Space) or
view all (a).
The configuration settings are listed by category in the following order:
1. Basic (serial port, Telnet and
web management status)
2. storm control
3. IP group management
4. syslog
5. QoS
6. port mirroring
7. traffic segmentation
8. port
9. port lock
10. 8021x
11. SNMPv3
12. management (SNMP traps
RMON)
current_config – Entering this parameter will display configurations entered without
being saved to NVRAM.
config_in_NVRAM - Entering this parameter will display configurations entered and
saved to NVRAM.
None.
13. vlan
14. FDB (forwarding data base)
15. MAC address table notification
16. STP
17. SSH
18. SSL
19. ACL
20. SNTP
21. IP route
22. LACP
23. ARP
24. IP
25. IGMP snooping
26. access authentication control
(TACACS etc.)
55