D-Link xStack DES-3800 Series Cli Manual page 292

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
Enter the new password again for conformation:*******
Success.
DES-3800:4#
show ssh user
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the SSH user:
DES-3800:4#show ssh user
Command: show ssh user
Current Accounts:
UserName
--------------------------
Trinity
DES-3800:4#
config ssh algorithm
Purpose
Syntax
Description
Parameters
Used to display the SSH user setting.
show ssh user
This command allows you to display the current SSH user setting.
None.
None.
Authentication
--------------------------
Publickey
Note: To configure the SSH user, the administrator must
create a user account on the Switch. For information
concerning configuring a user account, please see the section
of this manual entitled Basic Switch Commands and then
the command, create user account.
Used to configure the SSH algorithm.
config ssh algorithm [3DES | AES128 | AES192 | AES256 | arcfour |
blowfish | cast128 | twofish128 | twofish192 | twofish256 | MD5 | SHA1 |
RSA | DSA] [enable | disable]
This command allows you to configure the desired type of SSH algorithm
used for authentication encryption.
3DES – This parameter will enable or disable the Triple_Data Encryption
Standard encryption algorithm.
AES128 - This parameter will enable or disable the Advanced Encryption
Standard AES128 encryption algorithm.
287