D-Link xStack DES-3800 Series Cli Manual page 291

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
The SSH server configuration
max Session
Connection timeout
Authfail attempts
Rekey timeout
port
DES-3800:4#
config ssh user
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the SSH user:
DES-3800:4# config ssh user Trinity authmode Password
Command: config ssh user Trinity authmode Password
Enter a case sensitive new password: *******
: 8
: 300
: 2
: never
: 22
Used to configure the SSH user.
config ssh user <username> authmode {hostbased [hostname
<domain_name> | hostname_IP <domain_name> <ipaddr>} |
password | publickey]
This command allows you to configure the SSH user authentication
method.
<username> - Enter a username of no more than 15 characters to
identify the SSH user.
authmode – Specifies the authentication mode of the SSH user
wishing to log on to the Switch. The administrator may choose
between:
hostbased – This parameter should be chosen if the user wishes
to use a remote SSH server for authentication purposes.
Choosing this parameter requires the user to input the
following information to identify the SSH user.
hostname <domain_name> - Enter an alphanumeric string of
up to 32 characters identifying the remote SSH user.
hostname_IP <domain_name> <ipaddr> - Enter the hostname
and the corresponding IP address of the SSH user.
password – This parameter should be chosen if the user wishes
to use an administrator defined password for authentication.
Upon entry of this command, the Switch will prompt the user
for a password, and then to retype the password for
confirmation.
publickey – This parameter should be chosen if the user wishes
to use the publickey on a SSH server for authentication.
Only administrator-level users can issue this command.
286