D-Link xStack DES-3800 Series Cli Manual page 232

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
DES-3800:4#config pim ipif System hello 35 jp_interval 70 state enable
Command: config pim ipif System hello 35 jp_interval 70 state enable
Success.
DES-3800:4#
enable pim
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To enable PIM as previously configured on the Switch:
DES-3800:4#enable pim
Command: enable pim
Success.
DES-3800:4#
disable pim
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To disable PIM on the Switch:
Used to enable PIM function on the Switch.
enable pim
This command will enable PIM for the Switch. PIM settings must first
be configured for specific IP interfaces using the config pim
command.
None.
Only administrator-level users can use this command.
Used to disable PIM function on the Switch.
disable pim
This command will disable PIM for the Switch. Any previously
configured PIM settings will remain unchanged and may be enabled
at a later time with the enable pim command.
None.
Only administrator-level users can use this command.
DES-3800:4#disable pim
Command: disable pim
Success.
DES-3800:4#
227