D-Link xStack DES-3800 Series Cli Manual page 254

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
show ospf all
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To display the current OSPF interface settings, for all OSPF interfaces on the Switch:
DES-3800:4#show ospf all
Command: show ospf all
Interface Name: System
Network Medium Type: BROADCAST
Area ID: 0.0.0.0
Priority: 1
DR Address: 10.42.73.10
Hello Interval: 10
Transmit Delay: 1
Authentication: None
Interface Name: ipif2
Network Medium Type: BROADCAST
Area ID: 1.0.0.0
Priority: 1
DR Address: 123.234.12.34
Hello Interval: 10
Transmit Delay: 1
Authentication: None
Total Entries: 2
DES-3800:4#
create ospf virtual_link
Purpose
Syntax
Description
Parameters
Used to display the current OSPF settings of all the OSPF
interfaces on the Switch.
show ospf all
This command will display the current OSPF settings for all OSPF
interfaces on the Switch.
None.
None.
IP Address: 10.42.73.10/8 (Link Up)
Metric: 1
Administrative State: Enabled
DR State: DR
Backup DR Address: None
Dead Interval: 40
Retransmit Time: 5
IP Address: 123.234.12.34/24 ((Link Up)
Metric: 1
Administrative State: Enabled
DR State: DR
Backup DR Address: None
Dead Interval: 40
Retransmit Time: 5
Used to create an OSPF virtual interface.
create ospf virtual_link <area_id> <neighbor_id>
{hello_interval <sec 1-65535> | dead_interval <sec 1-65535> |
authentication [none | simple <password 8> | md5 <key_id 1-
255>]}
This command is used to create an OSPF virtual interface.
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
<neighbor_id> − The OSPF router ID for the remote area. This is
a 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx)
249