D-Link xStack DES-3800 Series Cli Manual page 77

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
show syslog host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show Syslog host information:
DES-3800:4#show syslog host
Command: show syslog host
Syslog Global State: Disabled
Host Id Host IP Address
-------
1
2
3
Total Entries : 3
DES-3800:4#
config system_severity
Purpose To configure severity level of an alert required for log entry or trap message.
Syntax config system_severity [trap | log | all] [critical | warning | information]
Description This command is used to configure the system severity levels on the Switch. When an event
occurs on the Switch, a message will be sent to the SNMP agent (trap), the Switch's log or
both. Events occurring on the Switch are separated into three main categories, these
categories are NOT precisely the same as the parameters of the same name (see below).
•
•
•
Parameters Choose one of the following to identify where severity messages are to be sent.
•
•
Used to display the syslog hosts currently configured on the Switch.
show syslog host {<index 1-4>}
The show syslog host command is used to display the syslog
hosts that are currently configured on the Switch.
<index 1-4> − Specifies that the command will be applied to an
index of hosts. There are four available indexes, numbered 1
through 4.
None.
Severity
--------------- --------------
10.1.1.2 All
10.40.2.3 All
10.21.13.1 All
Information – Events classified as information are basic events occurring on the Switch
that are not deemed as problematic, such as enabling or disabling various functions on
the Switch.
Warning - Events classified as warning are problematic events that are not critical to the
overall function of the Switch but do require attention, such as unsuccessful downloads
or uploads and failed logins.
Critical – Events classified as critical are fatal exceptions occurring on the Switch, such
as hardware failures or spoofing attacks.
trap – Entering this parameter will define which events occurring on the Switch will be
sent to a SNMP agent for analysis.
log – Entering this parameter will define which events occurring on the Switch will be
Facility UDP port Status
-------- --------
Local0 514 Disabled
Local0 514 Disabled
Local0 514 Disabled
72
--------