D-Link xStack DES-3800 Series Cli Manual page 245

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
config ospf area
Parameters
Restrictions
Usage Example
To configure an OSPF area's settings:
DES-3800:4#config ospf area 10.48.74.122 type stub stub_summary enable metric 1
Command: config ospf area 10.48.74.122 type stub stub_summary enable metric 1
Success.
DES-3800:4#
show ospf area
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example
To display an OSPF area's settings:
DES-3800:4#show ospf area
Command: show ospf area
Area ID
--------------
0.0.0.0
10.48.74.122
Total Entries: 2
DES-3800:4#
<area_id> − The OSPF area ID. The user may enter a 32-bit
number in the form of an IP address (xxx.xxx.xxx.xxx) that
uniquely identifies the OSPF area in the OSPF domain.
type [normal | stub] − Allows the specification of the OSPF mode
of operation − stub or normal.
stub_summary [enable | disable] − Allows the OSPF area import
of LSA advertisements to be enabled or disabled.
metric <value 0-65535> − The OSPF area stub default cost.
Only administrator-level users can issue this command.
Used to display an OSPF area's configuration.
show ospf area {<area_id>}
This command will display the current OSPF area configuration.
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
None.
Type Stub Import Summary LSA
------------- ------------------------------------
Normal None
Stub Enabled
Stub Default Cost
-------------------
None
Enabled
240