D-Link xStack DES-3800 Series Cli Manual page 242

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
disable ospf
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example
To disable OSPF on the Switch:
DES-3800:4#disable ospf
Command: disable ospf
Success.
DES-3800:4#
show ospf
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To show OSPF state:
DES-3800:4#show ospf
Command: show ospf
OSPF Router ID
State
OSPF Interface Settings
Interface IP Address
Used to disable OSPF on the Switch.
disable ospf
This command, in combination with the enable ospf command
above, is used to enable and disable OSPF on the Switch.
None.
Only administrator-level users can issue this command.
Used to display the current OSPF state on the Switch.
show ospf
This command will display the current state of OSPF on the
Switch, divided into the following categories:
General OSPF settings
OSPF Interface settings
OSPF Area settings
OSPF Virtual Interface settings
OSPF Area Aggregation settings
OSPF Host Route settings
None.
None.
: 10.1.1.2
: Enabled
Area ID State
237
Link Metric
Status