D-Link xStack DES-3800 Series Cli Manual page 214

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
Allowed Metric Type combinations are mettype 1 or mettype 2. The metric value 0 above will be
redistributed in OSPF as the metric 20.
Example Usage:
To add route redistribution settings:
create route redistribute dst rip src
Purpose
Syntax
Description
Parameters
Restrictions
Static
Local
DES-3800:4#create route redistribute dst ospf src rip
Command: create route redistribute dst ospf src rip
Success.
DES-3800:4#
Used to add route redistribution settings for the exchange of OSPF
routes to RIP routes on the Switch.
create route redistribute dst rip src [ local | static | ospf { all
|internal | external | type_1 | type_2 | inter+e1| inter+e2 }
]{metric <value 0-16>}
This command will redistribute routing information between the
OSPF and RIP routing protocols to all routers on the network that
are running OSPF or RIP. Routing information entered into the
Static Routing Table on the local xStack switch is also redistributed
src {all | internal | external | type_1 | type_2 | inter+e1 | inter+e2} −
Allows the selection of the protocol of the source device. The user
may choose between:
all – Specifies both internal an external.
internal – Specifies the internal protocol of the source device.
external - Specifies the external protocol of the source device.
type_1 - Calculates the metric (for RIP to OSPF) by adding the
destination's interface cost to the metric entered in the
Metric field.
type_2 - Uses the metric entered in the Metric field without
change. This field applies only when the destination field is
OSPF.
inter+e1 – Specifies the internal protocol AND type 1 of the
external protocol.
inter+e2 – Specifies the internal protocol AND type 2 of the
external protocol.
metric <value 0-16> − Allows the entry of an OSPF interface cost.
This is analogous to a HOP Count in the RIP routing protocol.
Only administrator-level users can issue this command.
0 to 16777214
0 to 16777214
209
mettype 2
mettype 1
mettype 2
mettype 1
mettype 2