D-Link xStack DES-3800 Series Cli Manual page 207

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
config vrrp ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set the authentication type for a VRRP entry:
DES-3800:4#config vrrp ipif Trinity authtype simple authdata tomato
Command: config vrrp ipif Trinity authtype simple authdata tomato
Success.
DES-3800:4#
show vrrp
Purpose
Syntax
Description
Parameters
Restrictions
To configure the authentication type for the VRRP routers of an IP
interface.
config vrrp ipif <ipif_name 12> [authtype [none | simple
authdata <string 8> | ip authdata <string 16>]
This command is used to set the authentication type for the VRRP
routers of an IP interface.
ipif <ipif_name 12> - Enter the name of a previously configured IP
interface for which to configure the VRRP entry. This IP interface
must be assigned to a VLAN on the Switch.
authtype – Specifies the type of authentication used. The authtype
must be consistent with all routers participating within the VRRP
group. The user may choose between:
none – Entering this parameter indicates that VRRP protocol
exchanges will not be authenticated.
simple authdata <string 8> - This parameter, along with an
alphanumeric string of no more than eight characters, to set
a simple password for comparing VRRP message packets
received by a router. If the two passwords are not exactly
the same, the packet will be dropped.
ip authdata <string 16> - This parameter will require the user to set
an alphanumeric authentication string of no more than 16 characters
to generate a MD5 message digest for authentication in comparing
VRRP messages received by the router. If the two values are
inconsistent, the packet will be dropped.
Only administrator-level users can issue this command.
To view the VRRP settings set on the Switch.
show vrrp ipif <ipif_name 12> vrid <vrid 1-255>
This command is used to view current VRRP settings of the VRRP
Operations table.
ipif <ipif_name 12> - Enter the name of a previously configured IP
interface for which to view the VRRP settings. This IP interface must
be assigned to a VLAN on the Switch.
vrid <vrid 1-255> - Enter the VRRP ID of a VRRP entry for which to
view these settings.
Only administrator-level users can issue this command.
202