Vlan Commands - D-Link xStack DES-3800 Series Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual

VLAN Commands

The VLAN commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
create vlan
delete vlan
config vlan
config gvrp
enable gvrp
disable gvrp
show vlan
show gvrp
Each command is listed, in detail, in the following sections.
create vlan
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a VLAN v1, tag 2:
DES-3800:4#create vlan v1 tag 2
Parameters
<vlan_name 32> {tag <vlanid 1-4094> | advertisement}
<vlan_name 32>
<vlan_name 32> {[add [tagged | untagged | forbidden] | delete]
<portlist> | advertisement [enable | disable]}
[<portlist> | all] {state [enable | disable] | ingress_checking [enable
| disable] | acceptable_frame [tagged_only | admit_all] | pvid
<vlanid 1-4094>}
{<vlan_name 32>}
{<portlist>}
NOTE: If you are plan to use access control, read the discussion
of the access profile rule limitations in Access Control List (ACL)
Commands below.
Used to create a VLAN on the Switch.
create vlan <vlan_name 32> {tag <vlanid 1-4094> |
advertisement}
This command allows you to create a VLAN on the Switch.
<vlan_name 32> − The name of the VLAN to be created.
<vlanid 1-4094> − The VLAN ID of the VLAN to be created. Allowed
values = 1-4094
advertisement − Specifies that the VLAN is able to join GVRP. If
this parameter is not set, the VLAN cannot be configured to have
forbidden ports.
Each VLAN name can be up to 32 characters. If the VLAN is not
given a tag, it will be a port-based VLAN. Up to 255 static VLANs
may be created per configuration. Only administrator-level users
can issue this command.
111
15