D-Link xStack DES-3800 Series Cli Manual page 257

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
Usage Example:
To delete an OSPF virtual interface from the Switch:
show ospf virtual_link
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To display the current OSPF virtual interface configuration:
DES-3800:4#show ospf virtual_link
Command: show ospf virtual_link
Virtual Interface Configuration
Transit
Area ID
--------------- ----------------------
10.0.0.0
Total Entries: 1
DES-3800:4#
DES-3800:4#delete ospf virtual_link 10.1.12 20.1.1.1
Command: delete ospf virtual_link 10.1.12 20.1.1.1
Success.
DES-3800:4#
Used to display the current OSPF virtual interface configuration.
show ospf virtual_link {<area_id> <neighbor_id>}
This command will display the current OSPF virtual interface
configuration.
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
<neighbor_id> − The OSPF router ID for the remote area. This is a
32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that
uniquely identifies the remote area's Area Border Router. This is
the router ID of the neighbor router.
None.
Virtual
Neighbor Router Interval
20.0.0.0
Hello Dead Authentication Link
Interval
------------ ----------- -------------------- ------------
10 60 None
252
Status
DOWN