Table 26: Com1 Port Configuration Commands; Table 27: Terminal Adapter Configuration Commands - MCK EXTender 3000 System Administrator Manual

Command Description
@P2= DTE speed - the speed at
which the COM1 serial port
is to run.
@P3= Parity
@P4= Number of data bits.
@P6= Number of stop bits

Table 27: Terminal Adapter Configuration Commands

Command Description
En Local echo
Qn Status messages - are AT command responses and
connection progress messages displayed.
Vn Message format.
Wn Carrier/Protocol result codes - are carrier and pro-
tocol messages displayed.
Xn Connect Messages - allows only a subset of all
result messages to be displayed.
S0= Auto answer - does the module automatically
answer an incoming call or wait for the AT answer
command to be issued before answering.
S1= Ring count. The value of this command never
increments.
EXTender 3000 System Administrator's Guide (Definity)
A - AT Command Set

Table 26: COM1 Port Configuration Commands

Values
2400, 4800, 9600, 115.2 19200, 38400,
57600<default>, 115200
N - none <default>
O – odd
E – even
7 or 8 <default>
0 - 1 stop bit <default>
2 - two stop bits
Values
n = 0- Disabled
1- Enabled<default>
n = 0- Enabled <default>
1- Disabled
n = 0- Numeric messages
1- Verbose messages <default>
n = 0- Disabled<default>
1- Enabled
n = 0- Enable result codes 0-4
1- 0-4, 17, 19,
2- All result codes <default>
Refer to the AT result codes sec-
tion for a description of the codes.
0 - auto answer disabled
<default>
1-255 auto answer enabled
000 (Compatible with BitSURFR
command lines)
Page 109