MCK EXTender 3000 System Administrator Manual page 98

Citel extender 3000: user guide
Hide thumbs Also See for EXTender 3000:
Table of Contents

Advertisement

Message
PPP connection established
Incoming PPP call
Disconnecting PPP call
PPP call disconnected
No active PPP call
Remote PAP authentication failed
Local PAP authentication failed
Remote CHAP authentication
failed
Local CHAP authentication
failed
<protocol> negotiation failed
Page 92
Table 16: Console Log Messages
Event
An ISDN data connection is successfully established.
An incoming ISDN data call has been made to the Extender.
The Extender is attempting to disconnect the ISDN data connection.
The ISDN data connection is disconnected.
An attempt was made to disconnect the ISDN data connection when
no such call is active. This message may be the result of using the
DISConnect command when no call is active.
PAP authentication with the device at the other end of the ISDN data
connection failed because the Extender sent an incorrect user name
and/or password to the device
The device at the other end of the ISDN data connection failed PAP
authentication because it sent an incorrect user name and/or pass-
word to the Extender.
CHAP authentication with the device at the other end of the ISDN
data connection failed because the Extender sent an incorrect user
name and/or password to the device.
The device at the other end of the ISDN data connection failed
CHAP authentication because it sent an incorrect user name and/or
password to the Extender.
PPP negotiation of options for the specified protocol failed. Possible
values for <protocol> are:
LCP - The device at the other end of the ISDN data connection
required the use of PPP configuration options that are not sup-
ported by the Extender.
Example: The device requires CHAP authentication, and the
Extender has been configured to only use PAP authentication.
BCP - The device at the other end of the ISDN data connection
is not configured for (or does not support) transparent bridging
across a PPP connection.
CCP – The device at the other end of the ISDN data connection
is not configured for (or does not support) Stac LZS compres-
sion. The data connection will be established but data compres-
sion will not be used on data traffic sent either way on the link.
EXTender 3000 System Administrator's Guide (Definity)
Ethernet Management Console

Advertisement

Table of Contents
loading

Table of Contents