Table of Contents
Advertisement
Setting PPP Parameters (Ethernet Data)
The Point to Point Protocol (PPP) is the data protocol used across the ISDN connection between the two
units. The Set PPP Parameters menu allows you to set the Data on Demand operation, compression and
PPP authentication options. This menu allows you access to the following menus:
•
Set DOD Mode
•
Set DOD Timeout
•
Set Stac Compression**
•
Set Receive Auth
•
Set Receive User Name
•
Set Receive Password
•
Set Send Auth
•
Set Send User Name
•
Set Send Password
**The stac compression menu is only displayed if STAC daughter card is installed.
For your convenience it is recommended to configure Ethernet Parameters using the Terminal Configu-
ration Menu.
Please refer to the Data Communication – Ethernet section for further details on PPP configuration.
Entering User Names and Passwords from the Telephone
To enter User Names and Passwords from the telephone, you may need to enter both numeric and non-
numeric characters. By pressing a key on the telephone keypad multiple times, you can see a list of one or
more alphanumeric characters. When the character you want to enter is displayed, the Drop/Redial key
should be pressed. Press the Drop/Redial key two consecutive times after you have entered the complete
user name or password. The table below shows the characters associated with the telephone keypad.
Table 8: Characters Associated with the Telephone Keypad
Dialpad Key
Alphanumeric Characters
1
'1'
2
'2', 'A', 'B', 'C','a','b','c'
3
'3', 'D','E', 'F', 'd', 'e', 'f'
4
'4', 'G', 'H', 'I', 'g', 'h', 'i'
5
'5', 'J', 'K', 'L', 'j', 'k', 'l'
6
'6', 'M', 'N', 'O', 'm', 'n', 'o'
7
'7', 'P', 'Q', 'R', 'S', 'p', 'q', 'r', 's'
8
'8', 'T', 'U', 'V', 't', 'u', 'v'
9
'9', 'W', 'X', 'Y', 'Z', 'w', 'x', 'y', 'z'
0
'0'
*
'*', '.', '_', '=', '-', '+', '%', '/', '?', '!', '@', '$'
EXTender 3000 System Administrator's Guide (Definity)
Remote Module Configuration
Page 47
Advertisement
Table of Contents
