Table of Contents
Advertisement
Ethernet Data Type Access of ETI/TTI Menu
If your Module's data type is Ethernet you can access terminal configuration at any time from the Ethernet
Console.
1.
To access the configuration menu you must connect a terminal or PC to the RS-232 port of the Office
Module. The PC must be running a terminal emulation package with terminal type set to VT100.
2.
Configure your PC COM port settings to match your Office module.The factory default COM port set-
tings, after power-up are: 57600 bps, No parity, 8 data bits, and 1 stop bit. If this has been changed set
your PC to use the current settings or use the Power-up Access Method (optional).
3.
From the Ethernet Console type MENU followed by a RETURN key from your PC. The Configuration
menu will appear.
Terminal Edit Line
The Terminal Edit Line is where features can be entered or modified.
The following edit line keystrokes can be used to modify parameters for both the ETI menu and the TTI
menu.
You can select a menu item by pressing:
•
A hot key (the number of the menu item).
•
The arrow up and arrow down keys and then press the Enter key when your menu selection is high-
lighted (ETI only).
You can modify the parameters accessed by the menu by pressing:
•
The Backspace key to erase the character to the left of the cursor.
•
The Enter key to accept the changes.
•
Arrow keys to change individual characters (ETI only).
Additional Terminal Commands
The display may become unrecognizable on occasion. If this occurs, press CTRL-R to refresh the display.
EXTender 3000 System Administrator's Guide (Definity)
Terminal Configuration Menu Operation
Page 19
Advertisement
Table of Contents
