Table of Contents
Advertisement
To Change a Password
1.
Select Change Password from the Password Menu.
2.
Press Enter. The system prompts you to enter the new password.
3.
Enter the new password (8 to 10 digits), beginning with the user's two-digit code.
4.
Press Enter.
5.
Repeat for each password you change.
To Disable a User
From the Passwords menu:
1.
Select Change Password.
2.
The system prompts you to enter the new password. Enter the two-digit user number you want to dis-
able.
3.
Press Enter. The user password is now disabled and the user will be restricted from accessing the sys-
tem. Any two-digit password automatically disables that user number.
4.
Repeat for each password you wish to disable.
Note: If "00" are entered, the following prompt will be displayed: "Password must be at least 8 digits long"
It will notify that the System Administrator password can not be disabled.
Exiting Password Menu
When you have completed your changes to the passwords, simply select 3 to Exit.
Configuring Passwords Online
Setting and changing passwords stored in the Office Module can be done through the Remote Module while
online with the Office Module (by accessing the Disconnect Menu).
Software Upgrades
All EXTender 3000, units can be software upgraded. Selecting this menu item prepares the module for a
Serial port Software Upgrade. For details, see the Software Upgrading section later in this manual. This
menu option is not required for initial configuration, but will be used later to upgrade your module, if
required.
Forced Upgrade
When this option is enabled the remote user will automatically be prompted to upgrade their remote unit on
the next login if the software in the office unit differs from that in the remote. No automatic prompt will be
displayed on the remote phone when this option is disabled.
Page 28
EXTender 3000 System Administrator's Guide (Definity)
Configuring the Office Module
Advertisement
Table of Contents
