Canon SADDLE FINISHER K3 Service Manual page 310

F05-101-04
• If the gap between the front aligning
plate and the front edge of the stack is 1
mm or more, turn off the power, and
shift all bits of SW973 to OFF to stop
adjustment. Then, adjust the alignment
range width, and then start over.
4) Press SW976 on the switch PCB.
• The stapler performs stapling.
5) Take out the stack, and check the sta-
pling position against the standard. If
the stapling position is as indicated, end
the adjustment.
Turn off the power, and shift all bits of
SW973 to OFF, and then turn on the
power once again. If you need to adjust
the stapling position, go to the follow-
ing step:
Direction of
delivery
F05-101-05
COPYRIGHT© 2001 CANON INC. 2000 2000 2000 2000 CANON SADDLE FINISHER K3/K4 REV.0 MAR. 2001
CHAPTER 5 TROUBLESHOOTING
6) Press SW976 once so that the machine
is ready to accept a new setting.
• The stapler moves to home position
once, and then returns to the stapling
position once again. LED 101 indicates
the latest setting.
7) Press SW975 or SW974 on the switch
PCB according to the result of compari-
son.
• Each press on SW975 shifts the stapling
position toward the front by about 0.42
mm. The reading of DSP971, on the
other hand, advances in the direction of
'+'.
• Each press on the SW974 shits the sta-
pling position toward the rear by about
0.42 mm. The reading of DSP971, on
the other hand, advances in the direction
of '-'.
8) As in step 3), insert several sheets of A4
or LTR paper into the handling tray.
9) Press SW976 once so that the machine
accepts the new setting.
• The machine executes stapling auto-
matically so that you can check the sta-
pling position.
10) Turn off the power.
11) Shift all bits of SW973 to OFF.
12) Turn on the power to move down the
swing guide.
5-3