Canon SADDLE FINISHER K3 Service Manual page 206

CHAPTER 3 MECHANICAL SYSTEMS
5) Shift up the latch claw (rear; [6]).
6) Disconnect the finisher from the copier.
1.1.4 Adjusting the Height
If the floor of the site of installation
causes a discrepancy in terms of machine
height, adjust the height of the machine as
follows:
1.1.4-1 Checking the Height and
Making Preparations
1) Compare the height of the top face of
the finisher top cover or the folder front
cover/rear cover and the top face of the
copier left cover. If the difference in
height is not as indicated in F03-101-
11/12, make adjustments. If jams occur
frequently in the finisher inlet, check to
find out if the height must be adjusted.
Change the height of the machine using
the casters shown in F03-101-10.
3-4
COPYRIGHT© 2001 CANON INC. 2000 2000 2000 2000 CANON SADDLE FINISHER K3/K4 REV.0 MAR. 2001
[6]
F03-101-09
F03-101-10