Canon SADDLE FINISHER K3 Service Manual page 232

CHAPTER 3 MECHANICAL SYSTEMS
8) Remove the rear upper cover and the
rear cover.
9) Remove the punch waste case holder.
10) Disconnect the ten connectors [13] of
the punch driver PCB and the connector
[14] of the punch fan; then, free the har-
ness [16] from the cord clamp.
11) Remove the two screws [17], and detach
the punch driver PCB [18].
12) Remove the two screws [19], and detach
the punch fan [20] together with the
base.
3-30
COPYRIGHT© 2001 CANON INC.
[19]
2000 2000 2000 2000 CANON SADDLE FINISHER K3/K4 REV.0 MAR. 2001
[17] [18]
[14]
[15] [16] [15]
F03-106-06
[20] [19]
F03-106-07
[17]
[13]