Canon SADDLE FINISHER K3 Service Manual page 200

Jam type
No pick-up paper
Feed skew
Feed delay A
Feed stationary A
Feed delay B
Feed stationary B
Inserter cover open
Inserter open
COPYRIGHT© 2001 CANON INC.
Sensor
S9 S9 The inserter paper set sensor did not detect any
paper during inserter pick-up.
PI62/63 There was a difference of more than 9mm in the tim-
ing at which the inserter feed sensors 1 and 2 (PI37/
38) came ON.
PI62/63 The inserter feed sensors 1 and 2 were not turned on
within 263mm of the inserter pick-up motor being
turned on.
The inserter feed sensor 1/2 were not turned OFF
492mm after being turned ON.
PI61 The inserter feed sensor 3 was not turned ON within
323mm after the inserter feed sensors 1/2 were turned
ON.
The inserter feed sensor 3 was not turned OFF
492mm after being turned on.
PI64 / 56 The inserter cover open sensors (front/rear) turned
OFF while the inserter was operating. (Not regarded
as a jam when the inserter is not in use.)
PI66 The inserter open sensor was turned OFF while the
inserter was operating. (Not regarded as a jam when
the inserter is not in use.)
T02-1407-01
2000 2000 2000 2000
CHAPTER 2 OPERATION OVERVIEW
Description
CANON SADDLE FINISHER K3/K4 REV.0 MAR. 2001
Code
0031
0033
001A
002A
001B
002B
0008
0008
2-169