Canon SADDLE FINISHER K3 Service Manual page 124

Type of Jam
Saddle inlet delay
Saddle inlet
stationary
Processing tray
stationary
(Note) The sensor or signal on the pick-up side differs depending on the optional accessories used and
pick up position.
Case 1: For inserter pickup, the inserter feed No. 3 sensor (PI36).
Case 2: If a folder is installed, the horizontal path residual paper sensor (PI33).
Case 3: If no folder is installed, or if the folder is disconnected (as a module), the copier delivery sig-
nal.
COPYRIGHT© 2001 CANON INC.
Sensor
PI59
PI59
PI8
PI31
2000 2000 2000 2000
CHAPTER 2 OPERATION OVERVIEW
Condition of Jam
This occurs when the saddle inlet paper sen-
sor (PI59) fails to turn on within 1.5 sec of
the sensor coming ON, on the pick-up side
of the saddle inlet paper sensor coming on.
This occurs when the saddle inlet sensor
(PI59) fails to turn off after feeding for a
specified time (equivalent to length of paper
+ 100). This jam is detected by the finisher
controller PCB.
When the the stack delivery sensor (P18)
detects a stack in the processing tray when
the knurled belt motor (M20) fails operate
for any reason.
CANON SADDLE FINISHER K3/K4 REV.0 MAR. 2001
Code
0015
0025
0026
2-93