Removing The Folder Driver Pcb - Canon SADDLE FINISHER K3 Service Manual

3.5 Removing the Folder
Driver PCB
1) Remove the rear cover.
2) Slide out the folder unit.
3) Remove the four screws, and detach the
belt cover (rear).
4) Remove the screw [1], and detach the
grounding wire [2].
5) Disconnect all connectors (9 pc.) from
the PCB; then, detach the folder drive
PCB [4] from the four locking supports
[3].
COPYRIGHT© 2001 CANON INC. 2000 2000 2000 2000 CANON SADDLE FINISHER K3/K4 REV.0 MAR. 2001
CHAPTER 3 MECHANICAL SYSTEMS
[3]
[4]
[3]
F03-305-01
[2]
[1]
3-83